Best Of

Hello Guys!

I need some help on how to trigger my TASCAM CD-400 to receive commands stop/play from BLU 100 over RS Serial 232. I have tried to configure the logic control but I am not certain if I have the serial trigger table set up correctly.
the purpose of the CD player is to play automatically the evac pre-corded message when then BLU 100 detects a fire alarm signal from the control input.
Does anyone have an example of how to set this up correctly in Audio Architect?

Thanks in advance!

https://tascam.com/downloads/products/tascam/cd-400u/rs-232c_protocol_cd400u_v1.10_e.pdf

Hello Everybody.
I have some old DSP's from Outline (Genius 5) I am pretty sure that it is BSS inside.
I just got some preset from Outline i would like to dump in the DSP.
But as my BSS ProgMove is a newer version (2.0) than the firmware in the DSP (1.02) i can not.
I do have contact between the DSP and the ProgMove.
Can anybody tell me how to update the firmware in the DSP ?
Or can anybody help me to get one old version of the ProgMove?
Really hope that someone can help me.
Kind regards
Lasse