Options
DBX DriveRack PA / Yamaha / QSC Configuration
srshep
Posts: 2
I would like help with following setup so that I can make sure that I am getting the maximum out of all of my components. If I am leaving any information out that is needed please let me know.
(1) DriveRack PA
(2) Yamaha S215V Frequency Response 42Hz - 16kHz
Power Capacity Noise 500W
PGM 1000W
Max 2000W
Nominal Impedence 4 Ohm
Crossover Frequency 1.5kHz
(2) QSC RMX1450 (Bridged Mono) 1400W @ 4 Ohm
These are each going to one S215V
(2) Yamaha SW218V Frequency Response 30Hz - 2kHz
Power Capacity Noise 600W
PGM 1200W
Max 2400W
Nominal Ompedence 4 Ohm
Crossover Frequency 90Hz / 12dB/oct.
(1) QSC RMX4050HD (Stereo Mode) 1300W @ 4 Ohm
Each channel going to SW218V
I would like the complete setup procedure for this amp/Speaker combo if possible. I am new to the DBX DriveRack. I did use the Wizard for initial setup but still feel like I am not set correctly. I noticed it didn't give an option to show that the High power was bridged. Any help would be greatly appreciated.
(1) DriveRack PA
(2) Yamaha S215V Frequency Response 42Hz - 16kHz
Power Capacity Noise 500W
PGM 1000W
Max 2000W
Nominal Impedence 4 Ohm
Crossover Frequency 1.5kHz
(2) QSC RMX1450 (Bridged Mono) 1400W @ 4 Ohm
These are each going to one S215V
(2) Yamaha SW218V Frequency Response 30Hz - 2kHz
Power Capacity Noise 600W
PGM 1200W
Max 2400W
Nominal Ompedence 4 Ohm
Crossover Frequency 90Hz / 12dB/oct.
(1) QSC RMX4050HD (Stereo Mode) 1300W @ 4 Ohm
Each channel going to SW218V
I would like the complete setup procedure for this amp/Speaker combo if possible. I am new to the DBX DriveRack. I did use the Wizard for initial setup but still feel like I am not set correctly. I noticed it didn't give an option to show that the High power was bridged. Any help would be greatly appreciated.
0
Comments
Also download the Driveware GUI. It will help you understand a lot about the DRPA.
DRA