Home dbx User Forum dbx Archive Threads Zone Pro 640/641 Zone Pro 640/641 Front Panel

Zone Pro Error Codes...

leviticuswleviticusw Posts: 3
edited September 2023 in Zone Pro 640/641 Front Panel
Upon boot-up I get this error code (well that is what the client is telling me).

!:meterc0010 failed
status = 4


We have to cycle this unit a couple times before it goes away. It only happens on the initial boot-up, when the unit is cold (has been turned off for the evening). It's used in a restaurant. Any suggestions on a fix?

Comments

  • GadgetGadget Posts: 4,915
    I have contacted tech support on your behalf...they should chime in soon...

    gadget
  • Still no answer. Anyone? Any help would be greatly appreciated.

    -Levi Walker-
  • GadgetGadget Posts: 4,915
    Hi,
    Sorry about that.. I did get a response from tech support saying that they were looking into it.. I have seen nothing since either.. I have re-contacted tech support..
    G
  • We confirmed with engineers that this error indicates a hardware problem with the DSP’s.
    Factory service is recommended.


    dbx Tech Support
  • i have the same problem ,.what is the solution?
  • GadgetGadget Posts: 4,915
    We confirmed with engineers that this error indicates a hardware problem with the DSP’s.
    Factory service is recommended.


    dbx Tech Support

    I don't know how much clearer that could be... that was Jason Mondragon from tech support...
This discussion has been closed.