NX 2200 Controller issue
Vinay_Kumar_Yadav
Posts: 1
Hi,
We found a problem in NX 2200 controller and problem is "Status, input and output LEDs is stable ON".
I have connected USB cable to re-program but the NX 2200 device not communicating with laptop, please support us to resolve this issue.
Thank you
0
Comments
As a first step, please flip dip switch 1 to ON and cycle power. Does this solve the issue?
Can you telnet or SSH into the device? If so, (and assuming you have source code to reload) can you issue a RESET FACTORY command?