New to this, be gentle lol
I took over a position at a new school as the systems administrator. The outgoing person left abruptly, leaving little to no information.
We have an E-Sports arena with 11 PC's (10 gaming and 1 for monitoring and announcing) and 11 TV's 48" (10 in a 5 X 2 array 1 on a far wall 75") . We have 11 N2300 decoders and 11 N2300 encoders as well as a N4000 audio encoder). These are all run through a Cisco 9200 48 Port POE Gb switch.
Right now, the PCs and TVs are all set one-to-one and working fine. But they would like to option or matrix some games on the screens on a 2 x 2 side by side or larger when needed.
Forgive me if I am missing info or not explaining correctly.
We currently are using N-able to make the one-to-one connections, but I can't seem to figure out the matrix portion.
Thank you
Comments
Basically, the decoders could be set up as a "wall":
https://amx.com/en/site_elements/instruction-manual-nmx-enc-n2312-nmx-dec-n2322-4k-series
Page 48.
Let's say, you want to show one source on a 2x2 wall. For this, all 4 decoders get the same stream source, and in that wall settings, you can define what section of the source stream the 4 decoders should show (top left / top right / low left / low right).
But this is hard to do only with nAble, as nAble is setting up the decoders individually.
Best would be to have a kind of controller, so such "scenes" could be called
There are several commands to do this from an AMX or 3rd party control system:
https://amx.com/en/site_elements/direct-control-api-nmx-enc-n2312-nmx-dec-n2322-4k-series
Or if there is not any kind of control system, and/or control gets complex, there is the SVSi N-series controller:
https://amx.com/en/products/sc-n8002
Can you recommend a controller? I will have a look around. I can't see this being the way they were using it. It would be nice to have presets for easy change.
I see it now, thank you.... I will have a look around.