Crashing Netlinx Studio
troberts
Posts: 228
I noticed this topic also in the posts for "TP4 deleting popups".
Here is what I have discovered. Yesterday I was loading a TP3 panel through an NI4000 with firmware .137 I had no problems. Today I am loading the same TP3 panel through an NI3000 with .141 firmware and Netlinx Studio is constantly crashing, to the point where I cannot load the panel via axlink. When I load the TP3 panel directly via 232 I have no problem.
I have assigned an IP address to the NI3000 and I have turned on dipswitch one. None of these fixed the problem. Anyone experience this? My guess would be there is some kind of problem with the new NI firmware .141
Here is what I have discovered. Yesterday I was loading a TP3 panel through an NI4000 with firmware .137 I had no problems. Today I am loading the same TP3 panel through an NI3000 with .141 firmware and Netlinx Studio is constantly crashing, to the point where I cannot load the panel via axlink. When I load the TP3 panel directly via 232 I have no problem.
I have assigned an IP address to the NI3000 and I have turned on dipswitch one. None of these fixed the problem. Anyone experience this? My guess would be there is some kind of problem with the new NI firmware .141
0