JVC D-ILA projector in IP ?

vincen

Hi,

I'd like to know if someone succeeded to establish and control D-ILA projector in Ethernet made by JVC ? The protocole explains you have to wait the PJ_OK string and then sends back in less than 5s the string PJREQ but each time I establish connection, I receive the PJ_OK from projector but I don't have time to send back the PJREQ that projector has already dropped the socket !
Any ideas ?

Thanks,

Vince

a_riot42

vincen wrote: »

Any ideas ?

Open the socket and send it?
Paul

DHawthorne

It sounds like the kind of IP devices that requires you reopen the socket for every exchange. You open it, send your command, get your response, the device drops the connection. It's not an unusual way to do IP; that's how web pages do it.

vincen

Nope, the problem is that there is an exchange of messages to do at connection but when you connect projectors send the initial message and I can't answer as it drops socket immediately JVC France has been unable to help me !

GregG

Have you tried the generic AMX PJLINK over IP module?

http://www.amx.com/inconcert/ct/DevMdlDetails.asp?A=Sh&MdlNo=29338&MdNo=0&DLM=1&lk=AF262EAA-DDCF-4EBA-A9B7-601260D1&FPMSN=

vincen

GregG wrote: »

Have you tried the generic AMX PJLINK over IP module?
http://www.amx.com/inconcert/ct/DevMdlDetails.asp?A=Sh&MdlNo=29338&MdNo=0&DLM=1&lk=AF262EAA-DDCF-4EBA-A9B7-601260D1&FPMSN=

Nope ! Did it in IR finally as I had only to power it on and off

Thanks nevertheless for your help,