Home› dbx User Forum› dbx Archive Threads› DriveRack 200 Series› 200 Series General Discussion

Routing and Configuration Assistance

JustBenJustBen Posts: 4
edited April 2011 in 200 Series General Discussion
Hello all,

I'm trying to configure my recently acquired Driverack 260 and I am not sure how to set the route how I desire.

Basically what I want is to run the 1 & 2 outputs for HF stereo, the 3 & 4 for MF stereo, then 5 as mono summed and 6 as mono summed so that I have different crossovers for the different sub woofers I'm running from 5 and 6.

Is this possible?

I have read through the manual and played around in the configuration area with unlinking 5 and 6 but I haven't figured out how to set them both to mono summed and have separate crossovers.

Cheers
Ben

Comments

  • DraDra Posts: 3,777
    Are you using the Driveware GUI?

    DRA
  • JustBenJustBen Posts: 4
    I have been using the front panel so far but planned on setting up Driveware tonight.
  • DraDra Posts: 3,777
    It is way easy on the GUI. Have you downloaded the tutorial? It will guide you through how to do what you want.

    DRA
  • JustBenJustBen Posts: 4
    No, I only read the users manual for the 260. I didn't realize there was a tutorial for Driveware..

    I'll check it out!

    Thanks. :)
  • DraDra Posts: 3,777
    Look in the training tab above.

    DRA
Sign In or Register to comment.