Home dbx User Forum dbx General Discussion

DBX 262 Project 1 Compressor / Limiter

I adjusted internal trim pots on my compressor and am not sure if returning them to how they were is the same.I'm assuming they are bias controls.Is this right and is there any way of getting them accurate again?


  • Options
    EEldeEElde Posts: 1,381

    I scoured everywhere and was unable to find any old calibration procedures on this discontinued product.

  • Options

    I remember reading it could only be recalibrated at factory.Its good to know I might be able to do it myself.
    Thanks HARMAN_EElde

  • Options
    EEldeEElde Posts: 1,381

    No problem! If I find anything I'll note it here.

Sign In or Register to comment.