AMX Jandy Module..
I usually write my own code but due to being in a pinch I used the Jandy Pool control module that AMX has written. Over the last month or so the Jandy Aqualink RS has been replaced once and the new one still ocasionally locks up. AMX will still be sending the polling commands every 3 seconds but the Aqualink does not respond until power is removed and put back. Tech support at Jandy thinks the unit could possibly have a loose power connector causing intermittent power outages and by reseting the power to the unit it is coming back online. Anyway, I am trying to determine whether there is a programming issue or an installation issue and of coarse I am programming this remotely and cannot go onsite to verify what the tech is telling me. Anyone out there using the same module and having problems?