Best Of
Re: Stuck on Starting Up.. NX-4200
Consider trying again on the used market if you are really just learning. The 1200 has the same processors, just fewer IO control ports, and can be found quite cheaply. Probably less than the bench charge to have yours just looked at.
Re: Stuck on Starting Up.. NX-4200
This debug indicates a problem in communication between the NX master itself, and the device 5001.
Either flashing the device 5001 failed for whatever reason and so the flash mem got corrupted, but could worst case also mean that the baseboard has a problem.
Unfortunately both would mean that this controller needs to get to repair at Harman.
Re: Stuck on Starting Up.. NX-4200
Both the master and Device Firmware are stored on the SD card on the SOM. While the Master firmware "stays" on the SOM (it is the OS, completely used on the SOM), the Device firmware after downloading will be transferred to the baseboard chipset. This seems to fail, and so there is no chance to fix that in the field. The chipset on the baseboard, if not completely defect, must be binary reflasht, which only can be done in the repaircenter.
Re: Master trying to connect to an IP address that doesnt exist on my Network
Is it in the URL list? (Diagnostics > URL listing)
Re: Unable to bind device to system
Your a genius! Thanks Marc! that was it! The ICSLan port was statically set!
Re: HARMAN Pro Forums to close in 2026
Hi,
Sad to see it go, very useful for me and I am sure others. Question, all posts/etc, will they be available in another format for querying after Dec 31st? There is a lot of valuable info in these forums, that I query quite a bit - it saved me a lot of times not having to contact Tech support and I could figure things out on my own.
Rob
Re: HARMAN Pro Forums to close in 2026
I "bump the counter" for providing the forum for read only after Dec 31st.
And I also "bump the counter" for a big message on the forum mainpage, that the forum gets closed end of the year.
Re: HARMAN Pro Forums to close in 2026
I agree that once in a while I use the forum to search for old topics that have slipped my mind. I visit the forum almost daily just to check and nothing much is happening here. Although I can understand that industries move forward, would it be possible to leave the forum in 'Read-only' mode? No new posts are possible, but it still can be searched. A big banner on the top of the page could make that clear. I've seen it elsewhere and it does work.
Re: Muse and TPDesign 5 ListViews, sanity check
the "-1" works in the fw version I have.
Fingers crossed that we get that release soon.
Re: Muse and TPDesign 5 ListViews, sanity check
The Varia Firmware 2.13.19 is officially released, which I had for testing the things above.