Got the Y cables... it works. Now, the next issue is: the level of the sweep signal is so low that even in a quiet basement, I keep getting a message saying that "high background noise detected" and "try again"... it does run, but if this is the best I can do, it will never work in a club before a gig, as sound of a few barflys chatting with the staff while we are setting up is WAY louder than my quiet basement... so... time to tinker and see if I can figure out a way to get the sweep signal to be higher...
Got the Y cables... it works. Now, the next issue is: the level of the sweep signal is so low that even in a quiet basement, I keep getting a message saying that "high background noise detected" and "try again"... it does run, but if this is the best I can do, it will never work in a club before a gig, as sound of a few barflys chatting with the staff while we are setting up is WAY louder than my quiet basement... so... time to tinker and see if I can figure out a way to get the sweep signal to be higher...
Update: I just re-ran with autolevel and autoeq together... this time, it set a decent level for test tone and worked great! Finally!!!
Comments
DRA
DRA,
Got the Y cables... it works. Now, the next issue is: the level of the sweep signal is so low that even in a quiet basement, I keep getting a message saying that "high background noise detected" and "try again"... it does run, but if this is the best I can do, it will never work in a club before a gig, as sound of a few barflys chatting with the staff while we are setting up is WAY louder than my quiet basement... so... time to tinker and see if I can figure out a way to get the sweep signal to be higher...
Update: I just re-ran with autolevel and autoeq together... this time, it set a decent level for test tone and worked great! Finally!!!